Upper assembly part for snow blower withe the blower part.
Upper assembly part for snow blower withe the blower part.
Upper assembly part for snow blower withe the blower part.
This is a used primary drive chain and sprocket set from an older Estate 1028 snowblower. Overall in good used condition, but there is a crack on one side of the hex sprocket.
Here is an extremely rare two speed transmission that came of of a 1979 Bobcat T5-2-20 snowblower. It is in good structural condition. This fits other Bob cat and Roto-hoe models as well, so please see the i. 17 for your application. This transmission still worked well on the blower. The dogs are not worn out and the reverse snaps in cleanly. The bearings all turn smoothly and tight showing normal wear. This unit is built so strongly (40 + lbs) that it strongly serves as a chassis for these tractor-like blowers. Most of these are now badly rusted and worse–locked up! This one shows some typical weathering they were prone to, but I didn’t see any rust or corrosion in the tranny box–well sealed and greased to the max! The compound shaft did loose it’s snap ring at one time, so a new one should be fitted prior to use. Four inspection cover mounting fasteners are included. This came off of a Colorado snowblower and brutal rust isn’t a big problem here in the dry high desert air. This is a hard to find part anymore and even more difficult to find in usable shape. Great for spare tranny parts too. Keep that ol’ Cat throwing snow over the barn! Thoroughly clean and lube prior to use. Please look at the pictures. Ask any questions that you might have.
This is the hex shaft/friction wheel assembly from a Simplicity 860E snowblower. Comes with drive sprocket and chain, plus bearings.
Ignition has been bypassed.
Honda snowblower HS622 tracks RH&LH.
This is a nice gear case from a rare Yamaha YS624W snowblower.
This is the friction plate/bearing assembly from a rare Yamaha YS624W snowblower.
This is a nice used set of auger gearcase halves from a Spirit snowblower. Any questions just ask. I have more parts for these machines, let me know what you need.
This is a nice used impeller shaft from a Toro Powershift 824, model # 38540. Gear is good, shaft is straight. Any questions just ask.